| Author | Message | ||
     Concerned Rating: N/A |
I have Edimensional 3d galsses and Geforece mx 440 card, when I had to move my computer and place it back together I hooked up the monitor back to the toggle and got no red tones all of a sudden. When I checked to see if it was the monitor I placed the monitor directly into the NVidia card and red tones were fine, placed the monitor in the toggle into the nvidia once more and the red tones are all gone. Do I have to set up the drivers all over again after I disconnected the Monitor or is it the toggle gone bad? Anyone know of this issue please reply....thanks! | ||
| Aig Rating: N/A |
May be the "red" line of E-D path-through is broken (don't remember what pin is it). Check pins in path-through connector, if all are OK - then something is wrong inside the box. |
